CLEANING & MAINTENANCE
Note: Turn off the device before performing any of the following steps!
MAIN BRUSH
The provided cleaning brush has sharp blades, keep it out of reach of children.
1. Disassemble the main brush by turning the robot over, lift the buckle and take
out the main brush.
2. Clean it by using the provided cleaning brush. Use the side with the hook to
pick up and cut hair and fibre and separate it from the main brush. Use the
cleaning brush to clean surface dirt. We recommend replacing the main brush
every 6-12 months.
SIDE BRUSH
1. Turn the robot over. Use a screwdriver to remove the screws and take off the
brush.
2. Clean it by using the cleaning brush that comes with the product. Use the side
with the hook to pick up and cut hair and fibre and separate it from the side
brush. Use the brush to clean the surface dirt. We recommend replacing the
side brush every 6-12 months.
TWO-IN-ONE WATER TANK AND DUSTBIN
Do not soak the water tank while cleaning the dust compartment. It is
recommended to replace the filter with an original one every 3-6 months to
ensure cleanliness.
1. Press the release button on the tank and pull it out.
2. Open the cover and throw the rubbish. Use the cleaning brush to clean it.
3. Take out the filter holder, remove the filter and clean it with the cleaning
brush.
4. Rinse the filter with clean water and allow it to air dry completely before reinstalling
it.
5. Rinse the dustbin compartment with clean water and allow it to air dry
completely before re-installing it. Make sure the parts are completely dry
before installing them. This is to prevent malfunction and dust clumping.
MOP
It is recommended to replace the mop with an original one every 3-6 months to
ensure cleanliness.
1. Remove the mopping module from the 2-in-1 water tank and remove the mop
from the mop holder.
2. Rinse the mop with clean water and allow it to air dry before using it again.
ROBOT
Do not use wet wipes, detergents, sprays or other chemical products to clean the
sensors, infrared recharging sensors, or charging electrode plates of the robot.
Use a soft and clean cloth to wipe the laser distance sensor, infrared lens,
charging electrode plates and cliff sensors.
Do not use wet wipes, detergents, sprays or other chemical products to clean the
infrared lens, charging pins and fan filter holder of the dustbin station.
1. When the dust bag is full, open the cover, pull the dust bag upwards to
remove it, throw it in the trash and replace it with a new dust bag. Close
the cover. The cover must be completely closed for the station to function
properly.
2. Use a soft and clean cloth to wipe and clean the infrared lens and the
charging pins to ensure that they are clean and free of debris.
3. Use a soft and clean cloth to wipe and clean the suction inlet to ensure that it
is clean and will make a tight seal against the robot.
4. Check the fan filter holder for any foreign objects or debris wrapped around
it. Use a soft and clean cloth to wipe and clean the holder to ensure it is clean
and free of debris.
